24 Like Unlike

New OC Oakridge Desert tan shingle roof

  1. 1
    Installing shingle at the edge

    Before the proper installation of the shingle.

     

    The roof edge, starter shingle seals to the dimensional shingle.

    Go To Pin
  2. 2
    Drip edge and starter

    Drip edge and starter at the edge of the roof.

    Go To Pin
  3. 3
    Ridge vent and ridge cap

    Ridge vent and ridge cap at peak of the roof.

     

    Go To Pin
  4. 4
    Clean look while roofing

    Good thing that we did not scratch any siding while doing the roofing.

     

    Go To Pin
  5. 5
    Flashing at the gutter

    Flashing at the gutter is very important.

     

    Go To Pin
  6. 6
    Cleaning the area after the roofing project

     

    Go To Pin

Rear roof, felted with synthetic underlayment

  1. 1
    Skylight process

    Skylight before and after flashing.

     

    Go To Pin
  2. 2
    Flashing a wall

    Proper step on flashing a wall. The wall is a little bit out of frame.

     

    Go To Pin
  3. 3
    The roof ridge

    The roof ridge was cut into half to exhaust away from the heat.

     

    Go To Pin
  4. 4
    The newly installed shingle

    The new shingle was installed nicely and straight on the new roof.

     

     

    pipe boot flashed correctly 

    Go To Pin

Job Location

This area is an approximation and does not represent the exact location

Litespeed Construction Asheville

Address: 460 Weaverville Rd #6 Asheville, NC 28804

Phone: (828) 505-6051